When i go to the carving choice and select one, my pointer comes up in rotate mode so i can't pick and place the carving. Any ideas?
joe
When i go to the carving choice and select one, my pointer comes up in rotate mode so i can't pick and place the carving. Any ideas?
joe
Click the Escape key
You might want to make sure that the "Reset tool after use" is checked under the Edit - Preferences
Also make sure you haven’t got the item “locked” to the Center of the board (both horizontally and vertically). If you do, then you cannot move the item - you can rotate it, but that’s all.
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com