Results 1 to 5 of 5

Thread: picking carving problem

  1. #1

    Default picking carving problem

    When i go to the carving choice and select one, my pointer comes up in rotate mode so i can't pick and place the carving. Any ideas?
    joe

  2. #2

    Default

    Click the Escape key

  3. #3
    Join Date
    Nov 2008
    Location
    Vancouver Island
    Posts
    8,167

    Default

    You might want to make sure that the "Reset tool after use" is checked under the Edit - Preferences

  4. #4
    Join Date
    Dec 2006
    Location
    Brunswick, GA
    Posts
    8,097

    Default

    Also make sure you haven’t got the item “locked” to the Center of the board (both horizontally and vertically). If you do, then you cannot move the item - you can rotate it, but that’s all.
    Michael T
    Happy Carving!


    ═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══

    Visit the CarveBuddy Website for Additional Exclusive Patterns and Resources

  5. #5
    Join Date
    Jan 2007
    Location
    NE PA USA
    Posts
    9,895

    Default

    Quote Originally Posted by mtylerfl View Post
    Also make sure you haven’t got the item “locked” to the Center of the board (both horizontally and vertically). If you do, then you cannot move the item - you can rotate it, but that’s all.
    Bet that is the most correct answer... So easy to overlook this...
    Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.

    Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074

    www.PoconoDigitalWoodshop.com

    www.AccountabilityTag.com


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •