Newbie....wasn't sure which category this question went in.

I often get the error prompt for my board not being the correct size. This machine is PICKY when it comes to exactness. I try to get as close as I can the exactness for board size. I leave an inch top and bottom and the 7" rule so I figure it's safe to say "no thanks" in the "scale board to size" prompt. I know I've been able to say "no thanks" in the past...however on todays cut it wasn't an option. It was "scale board" or "change board". I had to go with scale...I figured I was 1/16" at best off so how bad could it change the cut. WOW! It took my 14" x 6" cut and turned it into a 9" x 4" cut. That was quite the scale!

Has anyone NOT had the option to bypass the scale board option? Other than be exact in measurement - How can I avoid such a drastic size discrepancy?

Thanks!!!