Just acquired an old "A" machine that has only 10 hours on cut motor. After checking config. menu and access. menu, I can't get back to the project menu. The machine hasn't been run in about 9 years.
Any suggestions?
Ron
Just acquired an old "A" machine that has only 10 hours on cut motor. After checking config. menu and access. menu, I can't get back to the project menu. The machine hasn't been run in about 9 years.
Any suggestions?
Ron
Floyd helped me out! Press 0 then 5 then 3 and stop 3 times. Back in project menu. Hope this might help others!