I will lube everything that moves I can find and dust up/blow off
good. It has been covered. Anything else I should do/take care
of before firing up again?
I will lube everything that moves I can find and dust up/blow off
good. It has been covered. Anything else I should do/take care
of before firing up again?
Check the head pressure! Run it through the axis tests 0, 8 from the main menu. Have it do a board measurement to verify the accuracy for width and length. If you do not already have a dust collection attachment, GET ONE!
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Thank you, will do. Have dust collection
Remove the flex shaft and relube, sitting would allow the lube to dry out and harden. Lube the four corner posts as well.
And lube the vertical screw shafts whenever you lube the corner shafts.
Clint