So I did it. I replaced the bearings, all 8 with new covers. Replaced the y and z belts. Replaced cut motor brushes. Took me about 5 hours, going step by step through the manual.

Ran All tests and it all checked out fine. Just loaded a board for a 4 hour carve, this is the true test.

I found after doing all I did that the chatter I got when homing to check bit is gone. No y stall message yet.

Sounds like a kitten purring.

I was very nervous at the start, looked overwhelming at the start. Each piece according to plans and it's like a piece of cake.

Now, I see that there is really not a lot to the machine, being careful of cables and connectors. Lubricating everything was good and of course cleaning it up inside also was good.

Now I Am Somebody. Haaaaahaaaa

Sent from my SM-J700P using Tapatalk