Only got into carve about 4 minutes and it stops with a message, Clean Y Rails. I clean very well with a light coat of Teflon. Re start, runs a few seconds, same message, Clean again. Over and over about 8 times. I shut it off and quit for now.
I get a sick feeling in my stomach that there is more than cleaning needed.
It worked fine yesterday through 2 carves and no problems. How did it go from good to bad in my dark shop over night.
If anyone knows what I might need to do, sure could use a point in the right direction.
Thanks
Ed

Sent from my SM-J700P using Tapatalk