Hello all! Hope your New Year is going well!
Hopefully someone can give me a clue on this issue!
My board measures 60.125 by hand, the project board is listed as 59.789 because thats what the machine insisted it measured when I started. Now, having had to replace the Y bearings mid-carve, I'm trying to restart it, but it NOW says the board only measures 59.723! And no, the board has Not shrunk 0.066 in all the cold weather we've been having!
I've been docking around with this sign since Harvey and it's been nothin but problems! Had to replace the Z motor mid-carve of the Top of the sign, then the Y bearings mid-carve on this one as I said, now This! I've remeasured about a dozen times to no avail, then I reset the calibration.
Any clues would be appreciated!
Thx, Lee (aka KiltedGunn)