I load the bit and it goes through the motions then the head centers itself and says load bit. I even changed bits and it does the sane thing over and over.
Suggestions?
I load the bit and it goes through the motions then the head centers itself and says load bit. I even changed bits and it does the sane thing over and over.
Suggestions?
When the truck travels to the far side is the bit plate coming out all of the way and does the bit touch down 2 times on the bit plate? It sounds like it is not doing that. If the bit plate does not get pushed hard enough by the Y truck there is something interfering with it's movement. It can either be dirty Y rails/bearing, Y belt not tight enough, cut motor wires not tucked back into the corner of the top cover (if not the back of the Z motor will hit them) and/or the spring on the bit plate is dirty and needs to be cleaned and lubed.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
So the bit plate is not coming out then as it looks like in the picture the truck is not traveling far enough over to push the bit plate out. Go through the list of things to check. Also, with the power off push the truck over by hand to see if you feel any resistance and that the truck can move all of the way over to push the bit plate out.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
I actually thought it was supposed to touch the plate clamp that holds the board but its been so long I don't remember.