I am building a lamp out of a surveyor's tripod and transit as a donation for a group I belong to. I am trying to cut out a small table top that will fit inside the tripod legs with tabs that will slide into the 2 sides of each leg and rest on a leg support. I was hoping to be able to cut out the top using my CW, but don't seem to remember how to put the facets together and outline them. I can highlight all the aspects and simply use a bit to slightly mark them and then cut them out by hand, but the CW would do a nice job and be easier. Any help would be greatly appreciated. I thought I have done this before, but don't seem to remember how...

TriPodTableMod.mpc