I started freehand routing in August of 2016
Got my first "new" A series machine in September of 2017
It has an A907 motor
I Use the Aftermarket Musclechuck
http://okmatts.etsy.com
Right click on it and select remove. If you click on it and it wants a measurement, just hit escape.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
I started freehand routing in August of 2016
Got my first "new" A series machine in September of 2017
It has an A907 motor
I Use the Aftermarket Musclechuck
http://okmatts.etsy.com
Clicking on undo works as well.
I believe you can do a copy of the whole project then select and delete the project then past the project back. This I believe will delete all restraints at once. I don't have designer on my home office computer yet so I can't check.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com