This is how I clean the clear window on the board sensor. Cut down the back, remove the back bump and window. Blow out and use tape catching the window edge.
AL
This is how I clean the clear window on the board sensor. Cut down the back, remove the back bump and window. Blow out and use tape catching the window edge.
AL
Last edited by Digitalwoodshop; 12-27-2017 at 05:22 PM.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com