Hi all. I'm in search of a long running or repeatable Ivy or vine pattern to use on door and window casing. It will be going up the casing sides, then the top piece will have a quote on it.
TIA
Scott
Hi all. I'm in search of a long running or repeatable Ivy or vine pattern to use on door and window casing. It will be going up the casing sides, then the top piece will have a quote on it.
TIA
Scott
Hi Scott, I ran some 8' X 3 1/2" X 3/4" birch lumber with a vine pattern on. I got the pattern from the Pattern Depot and was able to connect them together dow =n the 8'. Try looking there.
Don't know if this will help you but is the only vine type of pattern I have.
CarverJerry
ver. 1.188 Win 7- 64b with 6 GB ram @ 2.8Ghz and dual 1Tb hard drives. Rock Chuck & Ringneck vacuum system hooked up to a Harbor Freight large vacuum. Center line text, conforming vectors.
I am making a vanity for my daughter. I have a purchased tree of life on the panel in front of the sink and vines on the stretchers and legs. For the vines I made parallel bezel curves and extruded a half round between them then Attached a leaf I got somewhere - not mine - spaced on both sides of the created stem. I copied and pasted as needed end to end to get the length for each panel. On some panels I moved the ends of the parallel lines apart to look like the base of the vine.
Thanks for the responses guys.
Hi Scott; If you are making a Pattern for an 8 foot door and window trim, you will need a pattern that repeats its self; for a 3 inch wide pattern, 10 to 12 inches long with the background removed. I made a rose bud pattern - the back ground is not all removed (it takes a lot of time to do that.)
I offer my patterns on CD and DVD's;
I work on Donations, I leave the donationsup to them. Except my CD and DVD's; I have a Minimum of $50.00 for the CD's(about 200 pattern files) and $100.00 for my DVD's (about 500 to 600 patternfiles) I fill the disk with data (max data per disk). I use the Designer 1.187version; all of CW's new updated programs can open my PTN files.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.
Nice. No problem with a donation but Paypal would be a better way to go.
Scott