softtware question

[joepei]

I am carving a crib board. It is primarily centerline text and lines with 1/8 holes drilled. Finished all the centerline and line cuts, machine was ready for the bit change to 1/8 to drill holes and i hit the enter button by mistake. Can i remove all the centerline cuts and leave the drilling code and carry on with the drilling?
Thanks

[fwharris]

Yes you can.

[Digitalwoodshop]

First rename the project then delete the stuff that is done and re run the project with the holes.

If you have a problem with the holes look for the yellow restraint numbers that can pull a hole off due to it wanting to answer the restraint measurement from the edge of the board. Turn them all green by selecting attachments.

Hole problems are a common post.... Out of position.

Good Luck,

AL