Very cool. My local base wood shop does this on their 8 ft bed cnc machine for shadow boxes.
Is that what you will be using it for? They churn a lot of them out.
I'm looking for the Air Force emblem or Logo for a friend that has a grandson that is going into the air Force. They want me to make them a plaque with it on. Thank you!!!!
Ducky, Air Force logo previously shared by a generous member under insignias and military pattern sharing thread a while ago.
https://forum.carvewright.com/showth...s-amp-Military
Last edited by oscarl48; 01-18-2018 at 10:31 PM.
oscarl 48, Thank you for letting me know where to look. I think that I found what they like.
Hard to see in the picture, but are the stripes and the circle recessed a bit? If so, it would be awesome to add an additional pattern for some inlay pieces so you can offset the woods. I've made a few MSgt and CMSgt stripe shadow boxes and have done it, it looks amazing. However, I did all my by hand with a router, and the help of a laser engraver to mark lines.