Maybe someone here can help. I've been fighting a z axis stall all summer everytime I contact support they have me change a part. I have changed the z motor, the bearings, the ribbon cable the head termination board and even the brushes on the cut motor. After the most recent changing of the head termination board because the z motor wasn's getting power I started a 58 minute carve and got through 14 minutes and there is the error again "Z axis stall Err. E06-0303". Sshut the machine down and tried to restart but as soon as I select the project the error appears doesn't even try to start the run. Any suggestions? I am about ready to toss this thing in the trash