Results 1 to 10 of 10

Thread: vintage camper

  1. #1
    Join Date
    Feb 2013
    Location
    St. Marys, Ga
    Posts
    70

    Default vintage camper

    I am in need of a vintage camper, I can not find one. just the simple old, can someone help me

    ElomSr

  2. #2
    Join Date
    Apr 2014
    Location
    Texas
    Posts
    2,535

    Default

    Simple camper so hopefully will fit your need. This pattern was a nice short break from learning 3d model texturing. Recommend a medium draft due to the thin spots I left on the edges. Otherwise should carve okay (don't see any obvious issues) but I have not carved it.

    Regards,
    - O
    Attached Thumbnails Attached Thumbnails CW Vintage camper.png  
    Attached Files Attached Files

  3. #3
    Join Date
    Jun 2007
    Location
    Northern Utah
    Posts
    563

    Default

    There is a group of campers in the Pattern Depot.

  4. #4
    Join Date
    Sep 2008
    Location
    Nuevo, CA
    Posts
    1,854

    Default

    Tell me how you did that Oscar.
    Clint
    CarveWright StartU team member
    Web Site WWW.clintscustomcarving.com

  5. #5
    Join Date
    Apr 2014
    Location
    Texas
    Posts
    2,535

    Default

    Clint, I built the model in blender very quickly and imprecisely. Since it was for the CW it is not the full camper. I just built the area that would show for the carving so I could control the depth of the carve and keep it shallow (2.5d).
    Attached Thumbnails Attached Thumbnails vintage campoer.png  

  6. #6
    Join Date
    Feb 2013
    Location
    St. Marys, Ga
    Posts
    70

    Default

    Deolman didn't see anything like I wanted thanks

  7. #7
    Join Date
    Feb 2013
    Location
    St. Marys, Ga
    Posts
    70

    Default

    oscarl148 thank you so much, that is what I have been looking for appreciate it.

  8. #8
    Join Date
    Feb 2013
    Location
    St. Marys, Ga
    Posts
    70

    Default

    oscral48 thank you so much that is what I have been looking for, I appreciate that so very much.

  9. #9
    Join Date
    Apr 2014
    Location
    Texas
    Posts
    2,535

    Default

    Elmo Sr., You are welcome. Hope it works for you and carves okay. Let me know if any tweaks are needed.

    Regards,
    - O

  10. #10
    Join Date
    Feb 2013
    Location
    St. Marys, Ga
    Posts
    70

    Default

    oscarl48 that works beautifully thank you again

    ElmoSR

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •