Go to 0 then 7 and check the status of your front and back roller.
Go to 0 then 7 and check the status of your front and back roller.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
I was going to say that Connie. With no board in the machine and the head cranked up, go to 0-7, curser down to rollers. reach in thru the top and pull up on the front roller. Reach from the back for the back roller (I am right handed). You should see the switch close and open. I am quite deaf and even with my powerful hearing aid, I could never hear a micro switch click. If it they don't change, squirt a bunch of air in at the end of the roller by that rubber washer looking thing until it does. Worst case, remove the end cover so you can see the switches and blow the dust out. Unlikely a switch is bad, just needs cleaning or adjusting.
Clint
OK. I cleaned out the ends of the rollers and took the side off again and cleaned the switches really good. Everything works fine now so I canceled the order. The only problem now is a y-stall about half way through the carve. Oh well. If it isn't one thing it's another.
Thanks for all the replies. Hope every one has a good week end...
George