Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Please load board message

  1. #11
    Join Date
    Aug 2008
    Location
    The Great Texas Gulf Coast
    Posts
    5,314

    Default

    Go to 0 then 7 and check the status of your front and back roller.
    CarveWright CX Packaged System - starting at $2000
    CarversClub 1 Year Subscription - $150.00/year
    Adv. Support w/out CC membership - $25.00/issue
    CarveWright Community Forum - PRICELESS!

  2. #12
    Join Date
    Sep 2008
    Location
    Nuevo, CA
    Posts
    1,854

    Default

    I was going to say that Connie. With no board in the machine and the head cranked up, go to 0-7, curser down to rollers. reach in thru the top and pull up on the front roller. Reach from the back for the back roller (I am right handed). You should see the switch close and open. I am quite deaf and even with my powerful hearing aid, I could never hear a micro switch click. If it they don't change, squirt a bunch of air in at the end of the roller by that rubber washer looking thing until it does. Worst case, remove the end cover so you can see the switches and blow the dust out. Unlikely a switch is bad, just needs cleaning or adjusting.
    Clint
    CarveWright StartU team member
    Web Site WWW.clintscustomcarving.com

  3. #13
    Join Date
    Mar 2013
    Location
    Fort Worth, Texas
    Posts
    407

    Default

    OK. I cleaned out the ends of the rollers and took the side off again and cleaned the switches really good. Everything works fine now so I canceled the order. The only problem now is a y-stall about half way through the carve. Oh well. If it isn't one thing it's another.
    Thanks for all the replies. Hope every one has a good week end...
    George

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •