It seems strange but my last carving quit with a y axis error and now my y positioning seems to be off by 6 inches. I have reset the calibration both for the Y axis individually and for everything, reformatted the card and redownloaded the latest machine code. but for some reason the whole y axis seems to be off by 6 inches. If I do a sensor check and read the Y axis it goes from -6 to 9. And if I do the y axis test, instead of coming all the way to the left when homing it only comes to the middle then goes to the right and hits the plate before it expect and stops with a y axis error. I put in a new FFC cable about a month ago so I doubt it is broken already.

I could I suppose put in a -6 inches on the y offset and see if that temporarily solves the issue, but I am thinking that is going to mask whatever the real problem is.

Suggestions?

Thnaks,
dave