Two sided carving problem (Help Please).

[NLAlston]

Since hinges would be difficult for this kind of project you might want to consider raised/recessed indexing to align the top and the bottom. Just a suggestion. I also made it a pierced project. I think that the irregular edges would make it difficult to sand otherwise. If you decide to use my example be sure to check all measurements to make sure everything aligns up properly. A test carve in scrap wood is recommended.

Just run it as a standard two sided carve.

This was done in version 3.1 using the extrude tool for the pen recesses.

Thanks, Steve. I'm saving YOUR version, also.