All,
I just returned from overseas after 6 months in the desert and the first thing I wanted to do was get back in the shop.
So I started a project and didnt even think to re-lube the flexshaft, and needless to say, I fragged it. So $75 later I replaced the flexshaft and all was good.
However, yesterday during a very simple 23 min project, I got a Z axis error and had to start over.
Now here's where it gets interesting, now I have no cut motor function. Normally when swapping bits in the setup, there is a short spin when the homing process starts, and now I have none.
It's essentially air carving with no motor power.
After review of some of the previous posts, I see it can be either the AC Cut Motor switch, Controller Cut Off Switch, or the X Termination board. Whats the easiest way to determine cause? Or is it just easier to replace all three?
Glad to be home....
Mike