Results 1 to 2 of 2

Thread: UCB Carve Issue

  1. #1

    Default UCB Carve Issue

    I am doing a new carve and using the UCB. This is the first time I have tried a 2 sided carve so was not sure how it would turn out. It carved the bottom correctly, centered and all. When I flipped the board, it carved way to the left,into the UCB. At one point in the setup, it asked me to jog to the front corner. I thought it was there so I hit continue. Should it be in the very corner of the board or where exactly should I be jogging it to?

    I would include pictures but my tabs did not hold and it all fell out of the UCB before I could take any.


    Overall, the carve came out great other than the top and bottom do not line up but it will give me a good way to see if it will work for what I am wanting.

    Any assistance will be greatly appreciated.

    Chris

  2. #2
    Join Date
    Nov 2008
    Location
    Vancouver Island
    Posts
    8,193

    Default

    You must have been using the "flip in jig" feature. See

    https://forum.carvewright.com/showth...429#post227429

    for the instructions.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •