-
Butterfly Box
This is my latest project. The original was designed by llwood on the Vectric forum and I adapted it for the Carvewright. Since I didn't have any 2" thick Cherry to make up the body I had to laminate 3/4" pieces together and then carved it with the 1/8" long bit as one piece. Really long carve! The hinge is made of small individual parts and is solid Cherry also except for the brass hinge pin and the small brass screws that secure each section to the lid. The lid is 7/16" thick Cherry and both halves were carved as one project at the same time.
Last edited by SteveNelson46; 06-19-2017 at 01:27 PM.
Steve
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules