-
New Board Sensor After Only A Month!?
Well, so much for carving my dad's birthday gift...
Got my machine almost exactly a month ago from Rockler, and have only put 46 hours on the rotary motor. Machine gets a good cleaning after every project; but, yesterday I got a Clear Board Sensor error. I've cleaned the sensor with no success. Went through the troubleshooting guide, and ran through the Sensor Check in the Configuration Menu. Sensor is only showing 2-3 when over a board.
Surely the board sensor hasn't gone bad already!?
Got an email in with Carvewright...so we'll see.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules