Results 1 to 4 of 4

Thread: error e04 0293 x axis

  1. Default error e04 0293 x axis

    keep getting this error. I measured a piece of wood and went to start a carve. the x axis starts for just a second then stops and gives error message. any ideas?

  2. #2
    Join Date
    Dec 2006
    Location
    Brunswick, GA
    Posts
    8,123

    Default

    Possible ideas...

    - broken x gear
    - board binding between edge guides
    - "bad" board (cupped, warped)
    - board too short (7" rule not followed)
    Michael T
    Happy Carving!


    ═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══

  3. #3
    Join Date
    Nov 2008
    Location
    Vancouver Island
    Posts
    8,193

    Default

    Try the x test: 0-8 and see what happens.

  4. Default

    I disconnected the servo motor. tested good. reinstalled. worked fine. poltergeist?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •