Does anyone have or know where I can get a star pattern for a flag.
Super Thanks
Tom
Does anyone have or know where I can get a star pattern for a flag.
Super Thanks
Tom
Custom Quilt Racks & Hangers
www.gwizpro.com
If you have the 3d add-on tools it is very easy to make your own. I used the "Sweep: Corner" tool here but you can also use the "Puffing: Bevel tool". It's about 8" square but if you save it as a pattern you can make it any size. Use the "Connected Lines" tool to trace over my vector lines to draw the star. Then use the sweep or puffing tool, group and save it as a pattern. You will then own the pattern and will be able to edit or change it.
Last edited by SteveNelson46; 05-19-2017 at 05:01 PM.
Steve
Hi Gwiz (Tom),
Just uploaded my flag stars at this post...https://forum.carvewright.com/showth...ique-for-STARS
Dev
Thank you!