Will something like this do?
Steve
That might work I I might need a couple things changed on the horse shoe.
John
John,
If you like this, send me a PM with your email address. It is designed as a pierced carving approximately 10" square and .4" deep and you can place text anywhere it will fit. The pattern is also available but you could just extract the pattern from the mpc.
Last edited by SteveNelson46; 04-19-2017 at 12:00 PM.
Steve
Thanks Steve
Thanks
John
John,
You have a PM. If you have any questions please post them here so others can benefit also.
Steve
Steve
I got it had to download the new software, guess I can't fight it anymore on my list to purchase next.
Is there a way to make it not a cut through on the inside?
need to put text in the middle of the horse shoe.
I also need to be able to make it bigger, like to be able to get it 13.0-13.5 wide.
Also how would it look with the areas that you removed from the earlier post i asked, he would like them in there. But wondering how the letters would look like.going from the different depths.
also could leave the areas marked empty.
thanks.
John
jaustin you have a private message
Henry
Every one has a photographic memory. Some just don't have film.
I did this modification but I'm not sure of what you want to do with the nail recesses and nail holes. The other example is just a suggestion on how to place a name or text. The project you are attempting to do is not a beginner's project but if you "stay with it" it will be a good one to learn by.
Steve