I haven't used the forum in ages, so I may as well be a newbie, again. I've taken on a project for an association I belong to and am needing to run through many small pieces (the smallest are 5" x 4"), and carve an inscription in centerline on the surface. So I need to make a sled to mount these pieces on. Has anyone got any tips for me in building the sled. It would need to be able to handle the small pieces 4 wide by 5 inch long, and some larges pieces. The largest pieces will be 6 long by 4 wide, so I suppose the sled has to be adjustable. I'd like to have a few ideas from members here who have already done this, in order not to repeat mistakes already made. Any help would be appreciated. If there is an article on this or another post that has already been done on it, just point me in the right direction. Thank You.
Dixie