Is it possible to bypass the AC switch on the cover? I know it's a safety thing, the close cover switch would still be intact.
Is it possible to bypass the AC switch on the cover? I know it's a safety thing, the close cover switch would still be intact.
Kansas Wood Shop
Disabled Veteran owned and operated
Visit www.kansaswood.com
A machine with rock, CS machine, Designer 3, centerline, conforming vectors
The safety police will jump in but I bypassed both my switches years ago. but yes the easiest place to do it is in the back corner where they sometimes hit the truck. The wires have connections where they go from the lid to the motor. Disconnect there and use a piece of wire to connect the black to the white. This will bypass the switch. You can do this to test the switch. Once you do this you can run a cut motor test. Its then up to you how long you want to leave it this way.
Steve
I bypassed both of my switches a couple years ago as well and am happy with my decision. As with all tools, pay attention and keep your fingers away from the spinny things.
I also have LED lights powered through the power switch so they turn on whenever whenever the CW is on. The safety police would be all day writing up my warrants.
I agree with SteveNelson46, if you bypass one, you should bypass them both.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
There is no need to bypass it if it works!! Test it. Do you hear it click?
Mine still clicked but did not work. once I bypassed motor worked perfectly. There are replacement controller side switches on ebay but not the motor side switch. LHR shipping is way too high for this little part.
I did not mean that it works if it clicks. It, however, does not work if it does not click! One needs to check for continuity.
(I believe that not clicking because of the cover held up by a DC is the most common reason for cut motors not running.)
I replaced the switch with one from my parts machine. All is well now, thanks for all the input!
Kansas Wood Shop
Disabled Veteran owned and operated
Visit www.kansaswood.com
A machine with rock, CS machine, Designer 3, centerline, conforming vectors