Ok so i'm doing a important project, the machine managed to finish a 2.5 hr carve but then when it had to do the last bit; some centerline text like shown in the pic, the cut motor would not spin up. After a couple times of stopping and trying to start with no success it aborted the project. I tried to do a user test and it said the cut motor was running when it wasn't. Is it the cut motor or a sensor?
Second question is how to do the text. I can do a MPC with just the text easy enough, but how to fool the machine to do it in the carve region already there? The surface would be only 3/8" thick. I'm guessing I have to put it on a sled, then when it goes to find the surface move the bit to the carve region?
If it matters this is my CS machine