Yes, that is why I made the extrude into a pattern. You cannot edit the pattern but you can carve it. (You would not have been able to carve the extrude.)
Yes, that is why I made the extrude into a pattern. You cannot edit the pattern but you can carve it. (You would not have been able to carve the extrude.)
I want to cut a inverted dome in the surface of a piece. The depth of the dome needs to be 0.459" deep. The attached image file shows, in cross section, what I want to do. This will give it a radius of 1.75"
My attached designer project shows this piece in the center. As you can see from this file, it looks like the sides are .459" deep.
Is there a way to make the dome like it want it?
All you need to do is set the height to 999 it was set to 100
Using Designer Version 1.187 Donations are always welcomed, thanks – send a check to my PO Box 652