been getting , every time I open upt ,,shows shows error why update
been getting , every time I open upt ,,shows shows error why update
Henry
Every one has a photographic memory. Some just don't have film.
If you have auto update on (Help_Check for Updates Automatically checked) then you will be directed to the LHR web site update page whenever you start Designer. This gave a 404 for awhile but now I think it is fixed. It should take you to: http://www.carvewright.com/update3/?major=3&minor=102
If you do not want to update, you should uncheck the auto update in the help menu.
downloaded and upgraded to the new software version, it said there was a change in the cut motor startup procedure because the newer cut motors were more effecient. When my shop is below 65 degrees my cut motor always stops after about 10 seconds and says check cut motor, I press enter and it finishes the job. This morning shop is probably 50 degrees and for the first time at that temp it did not stop and give that error. I don't know if they intended to fix my problem, but thank you LHR.
dave
I'm being asked to register the new update.... like I had just purchased the software. Did anyone else have to do this with the update?
Last edited by SteveNelson46; 03-02-2017 at 02:45 PM.
Steve
I down loaded and installed as admin with win10 and had no issues. Designer started up as normal.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
I have seen it consistently on my machine for years now anytime the temp in my shop goes below 55 degrees. Which means pretty much every carving from November to April.