Big problem here

[Shacky]

I guess that firmware update for the cut motor did the trick. I just did a pretty big project and had no problems at all. Thanks for all the help!

Just wondering. I put in a new cut motor with about 8 hours on it now. Any way to reset my machine cut motor hours to reflect that there is a new cut motor in it?

[fwharris]

The machine hours are stored on the machine computer and the only ones I know of to do that are the CW techs. I right down my cut motor hours to keep track.

[Shacky]

Thanks. Maybe a little sharpie note on the side of something.

The machine hours are stored on the machine computer and the only ones I know of to do that are the CW techs. I right down my cut motor hours to keep track.

[normrichards]

Don't forget to change your motor brushes at about 250 hours to keep this motor running.

[alan19512]

Flex shaft is catching lip on top of carvewright and causing z axis stall. Quick fix?

[bergerud]

Usually the flex hits the back of the slot, not the front. The top hat on the truck wears out and the flex tilts back. Your case seems opposite.

Maybe your top cover is moved back. Check the screws and see if you can move it forward? Is the top cover warped? Is there something pushing the flex forward? Is the truck rolling properly on the rails?

[Digitalwoodshop]

Posted on the Facebook page He found one of the support wires on the outside of the flex came off causing the problem.