Hello All,
I am working on a table for my machine. It is going to be a simple one. I do not have the machine right now but I need to know the bolt pattern dimensions for the machine. The bolt holes the hold the machine to a table.
Thank you
Junior Member
Machine Bolt pattern ?
Hello All,
I am working on a table for my machine. It is going to be a simple one. I do not have the machine right now but I need to know the bolt pattern dimensions for the machine. The bolt holes the hold the machine to a table.
Thank you
Experience is a doorway -- Not a final goal.
Senior Member
The table top would need to be around 17" by 23" for the base to fit on it. The bolt holes are around 15.2" and 18.2" (I would wait for the machine to actually drill the holes.) Anyone else confirm?
Senior Member
I made this cabinet before there were any dust collection systems so there is a dead space at the top for the downdraft system with a 4" DC adapter on the back side. The top is 28" by 40" and the holes for the mounting bolts were marked after the cabinet was made and are pretty close to Bergerud's measurements
Last edited by SteveNelson46; 01-16-2017 at 11:38 AM.
Steve
Senior Member
CW machine stand
This my machine stand, they works very well, lot of storage under the table,
I bought a stand, placed a top on it cut a slot in the top. no need to bolt it down.
with that much weight , it is not going anywhere. The nice part is I can roll it anywhere.
My Shop 1044
CarveWright START U Team Member
V - 1.187 and 3.0 too
With the DC Insert," dust all gone"
CarveWright Customer Documentation http://www.carvewright.com/2010CWweb/maintenance.htm
CarveWright Tips and Tricks http://www.carvewright.com/2010CWweb/tips.htm
www.customcarvingsbyperry.com
I have often wondered why it is that
Conservatives are called the "right" and Liberals are called the "left".
"The heart of the wise inclines to the right, but the heart of
the fool to the left."
Posting Permissions
Reply With Quote