I carved the project shown in the 1st photo and then after loading the centerline bit got a message "bit depth does not match" (which I often get with 1 of my machines). I selected the alternative "continue (which usually works). However the text was only air carvig and not touching the surfacr in the now carved areas inside the footprint .I am wondering if there is a workaround to save the project such as deleting the patterns and uploading only the text and then reloading the board? Or is there a way to mahe the text carve in the now lowered areas inside the footprint and around the ring by getting the machine to touch down in these lowered ?carved areas for initial bit setup measurement? ANY ADVICE WOILD BE GREATLY APPRECIATED if anyone can understand this less than cogent explanation. Thank you as always