I am trying something I have not attempted before. I am wanting to use CW to cut out letters in a 12 x 96 1/2 board . I plan on using 4 panels and then using them as a stencil on a 3/4 painted plywood. I have all panels layed out with text only. I selected the outline option in the text box. I then set the bit selector to 1/8th inch bit at .52 depth to ggo through the plywood. So far so good, but as I visualize this being carved I can see alot of little parts flying around and jamming something. No option to set tabs in the letters to hold in place. I did some text to start with and tried to outline the letters like I would a pattern, but no option. My other option was to set the carving depth at .49 instead of 1/2 so it barely cuts through. I need input if anyone has every tried to make letter stencils like this. All text, no graphix to contend with.