How do you replace the front cover? When mine came back from the factory, it was broken, and they sent a replacement.
Thanks,
Ron
How do you replace the front cover? When mine came back from the factory, it was broken, and they sent a replacement.
Thanks,
Ron
You will need to remove the head cover first http://www.carvewright.com/assets/se...head_cover.pdf
It is best to disconnect the power connection to the cut motor so that you can lay the cover upside down. There are two screws on each end of the cover that hold the hinge pins in place. It should be obvious once you get the cover off.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
You will need a smaller Philips screwdriver, a #1 is the size you will need.