Ran into an oddity this morning, perhaps the veterans of the group can enlighten me.
Simple coaster project, one centerline letter and a circular cut.
Centerline running a 60 degree bit
Circular cut running the 1/8 inch bit.

Odd part was that the circular cut ran first, then the letter

Running 1.187
Material is vinyl flooring, app .305” thick.Material on a .75 inch sled

Circular cut was not a true “cut path”, but rather a circle cut to .305 depth.
Had this been solid material, would have seen no problem.However, since the material is running on a sled and the circular cut ran first, I was quite concerned the now circular “blank” would move when the letter was carved.

Had the foresight to put double-stick tape between the material and the sled and all carved/cut OK. But had my finger on the Stop button just in case.

Is there a way to reverse the cut order, given the above information?

Thanks!

keninar