I didn't realize you wanted a trough. My example was just a pocket cut so I missed the point entirely.
I didn't realize you wanted a trough. My example was just a pocket cut so I missed the point entirely.
Steve
That would be great, i do not have 3D yet. The poker chips come in 39 and 40mm. I am going to make for the 40mm so i am covered for both. The trough would have to be 4"L x 1 11/16"W x 3/4"D.
Thanks for all the help.
joe
See if this works. (mpc in 2.007)
Thanks! looks perfect. I will give it a try.
Joe
It worked great, i will post a pic when the table is done. Thanks!