Setting lines to a specific angle

[keninar]

Another quick question that I'm quite sure a quick answer exists - but cannot for the life of me see it.

Using designer 1.187, can a draw a line and set it to an angle that is not an integer, i.e. set a line to 22.5 degrees?

When I attempt to enter the angle in designer software doesn't seem to recognize the decimal.

Thanks

keninar

[bergerud]

This is a bug with the edit box on the tool bar. Right click on the line and choose orientation-set angle. A small edit window will appear on the board and it will accept the decimal.

[SteveNelson46]

This is a bug with the edit box on the tool bar. Right click on the line and choose orientation-set angle. A small edit window will appear on the board and it will accept the decimal.

Hmmm! I didn't know that either.

[keninar]

Thank you, Kindly!
That did the trick.
[I knew there was an answer - I just wasn't experienced enough to figure it out]

Thanks again!

keninar