need brush cap

[cestout]

I just replaced the X trerm board in my C machine - again- and went to check the brushes. The top cap came out with a little struggle (and the brush needed replacing) but the bottom one was welded in place. I took the motor apart and end up carving the cap out with my dremel only slightly bollixing up the threads. I put the cap from the top in the bottom and put the motor back in the machine. Does LHR sell the caps? If not, does anyone know where I can get one?
Thanks
Clint

[bergerud]

What about: http://forum.carvewright.com/showthr...390#post187390

[SteveNelson46]

I just replaced the X trerm board in my C machine - again- and went to check the brushes. The top cap came out with a little struggle (and the brush needed replacing) but the bottom one was welded in place. I took the motor apart and end up carving the cap out with my dremel only slightly bollixing up the threads. I put the cap from the top in the bottom and put the motor back in the machine. Does LHR sell the caps? If not, does anyone know where I can get one?
Thanks
Clint

Clint,

I bought 10 on ebay awhile back. PM me with your address and I'll send you a couple.