-
Universal Carrier Base
This is my first time on the forum. I just finished constructing the CW universal carrier base and I'm having a problem using it in the machine. I mounted the board according to instructions and slowly turned down the crank and pressed enter to proceed. The machine read the width OK, but will not read the length. the machine moves the carrier base in the x direction beyond the board and beyond the rollers and displays "Edge detection failed err E03-0400.
Wondering if folks on the forum could give me some suggestions as to what I am doing wrong or what to do to correct it. just a note: I have no problem running the board on the belt. The board measurements are accurate.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules