The Y problem

[henry1]

Would anyone know why 3/4 in the project the Y goes across and goes deeper at one point like drilling a hole and the the Y error come up I can see why it stop at one point , has this ever happen to anyone here a picture of the pattern I just don't know why it did it to me all was running good to that point

[bergerud]

Losing track of the z depth is usually due to a bad FCC (ribbon or connection) or a z encoder disc problem (dust or loose).

[henry1]

Losing track of the z depth is usually due to a bad FCC (ribbon or connection) or a z encoder disc problem (dust or loose).

Thx berg will check on that