Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: Cutout problem

  1. 10-18-2016 #11
    dante4488
    dante4488 is offline Junior Member
    Join Date
    Oct 2016
    Posts
    19

    Default

    I will check these parts, but I sure hope not the machine has less than 25hours on it.
    Reply With Quote Reply With Quote
  2. 10-18-2016 #12
    SteveNelson46's Avatar
    SteveNelson46
    SteveNelson46 is offline Senior Member
    Join Date
    Feb 2008
    Location
    Tucson, Arizona
    Posts
    2,401

    Default

    A good place to start is re-calibration of the axes. Here is a link to the documentation that will tell you how.

    http://www.carvewright.com/assets/se...alibration.pdf
    Last edited by SteveNelson46; 10-18-2016 at 04:05 PM. Reason: Spelling
    Steve
    Reply With Quote Reply With Quote
  3. 10-18-2016 #13
    dante4488
    dante4488 is offline Junior Member
    Join Date
    Oct 2016
    Posts
    19

    Default

    Thank you very much sir. Will try it as soon as I get home.
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules