-
I will check these parts, but I sure hope not the machine has less than 25hours on it.
-
A good place to start is re-calibration of the axes. Here is a link to the documentation that will tell you how.
http://www.carvewright.com/assets/se...alibration.pdf
Last edited by SteveNelson46; 10-18-2016 at 04:05 PM.
Reason: Spelling
Steve
-
Thank you very much sir. Will try it as soon as I get home.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules