Results 1 to 6 of 6

Thread: Keypad Issue

  1. #1
    Join Date
    Aug 2007
    Location
    St. Joseph, MO
    Posts
    171

    Angry Keypad Issue

    ALL,

    This is a new one for me....

    Just cleaned the rails and the nuts due to crank down binding. Machine is reassembled, went to start a new project, and when the "Stay Under Rollers" pops up, I cannot get 1 or 2 to respond. I tested from the "home" bootup screen, no problem. Both function appropriately.

    Any ideas??

    Mike

  2. #2
    Join Date
    Feb 2008
    Location
    Tucson, Arizona
    Posts
    2,401

    Default

    Check both ends of the cable and connections that run to the inside of the keypad end panel. You may have to remove the end panel to check the connection at the bottom.
    Last edited by SteveNelson46; 10-11-2016 at 03:12 PM.
    Steve

  3. #3
    Join Date
    Apr 2013
    Location
    Cornwall, Ontario, Canada
    Posts
    1,344

    Default

    Same problem, switch was stuck.

  4. #4
    Join Date
    Nov 2008
    Location
    Vancouver Island
    Posts
    8,176

    Default

    Sounds like it could be a software issue. Re-format and re-flash the card.

  5. #5
    Join Date
    Aug 2008
    Location
    The Great Texas Gulf Coast
    Posts
    5,375

    Default

    Quote Originally Posted by flyingemt View Post
    ALL,

    This is a new one for me....

    Just cleaned the rails and the nuts due to crank down binding. Machine is reassembled, went to start a new project, and when the "Stay Under Rollers" pops up, I cannot get 1 or 2 to respond. I tested from the "home" bootup screen, no problem. Both function appropriately.

    Any ideas??

    Mike
    Do the down / up arrows and enter key work? (Workaround...not sure about keypad, unless not plugged in all of the way or tear in cable.)
    CarveWright CX Packaged System - starting at $2000
    CarversClub 1 Year Subscription - $150.00/year
    Adv. Support w/out CC membership - $25.00/issue
    CarveWright Community Forum - PRICELESS!

  6. #6
    Join Date
    Aug 2007
    Location
    St. Joseph, MO
    Posts
    171

    Default

    Found the issue, it would seem the first 3 wires in the ribbon have torn. Back in shape tomorrow, after $10 for the cable, and $59 in overnight shipping, lol.....

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •