Results 1 to 4 of 4

Thread: Nutcracker model

  1. #1
    Join Date
    Apr 2014
    Location
    Texas
    Posts
    2,928

    Default Nutcracker model

    Finished a test carve on the nutcracker pattern. Two piece glue up for front and back. Next step is to seal it and then paint it. I'll be gluing a small base to or use it as an ornament. Not sure yet.
    Attached Thumbnails Attached Thumbnails nutcracker image and pattern.jpg   nutcracker front.jpg   nutcracker back.jpg  

  2. #2
    Join Date
    Jan 2008
    Location
    As of 6/2021 Punta Gorda, Florida
    Posts
    1,458

    Default

    You did an excellent job with the nutcracker. Hope this is headed to the pattern store.

  3. #3
    Join Date
    Apr 2014
    Location
    Texas
    Posts
    2,928

    Default

    Sharon, I'm planning on submitting just the front for the pattern store. This was an experiment for me. I've hard zero luck doing two sided carves so tried an stl cut pattern. Still didn't line up perfectly but it was close.

  4. #4
    Join Date
    Sep 2008
    Location
    Nuevo, CA
    Posts
    1,854

    Default

    In the store there is an owl - front and back and a puppy (Hound) front and back. Individual patterns. I use them for my bottle stoppers - carve both front and back and glue them together then sand to match. So - submit both back and font and let prople decide if they want one or both. I would like to try carving thru and make a functional nut cracker with a movable jaw.
    Clint
    CarveWright StartU team member
    Web Site WWW.clintscustomcarving.com

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •