How do I carve a pattern that will be 45" by 42" ? I seem to remember someone explaining it at the conference a year or two ago, but the instructions didn't seem to find a home in my memory. Thanks!
How do I carve a pattern that will be 45" by 42" ? I seem to remember someone explaining it at the conference a year or two ago, but the instructions didn't seem to find a home in my memory. Thanks!
You carve it on 3 boards. You would put the bottom 1/3 on an 11" board 1/4" from the bottom edge, save that as bottom, slide the whole thing down until it is centered vertically, save that as middle. Then slide everything down until the top is 1/4" fro the top edge and save that as top. Now carve those 3 boards on 12" wide boards so you have edges for the rollers to ride on. YOU will have to trim the pieces to line-up, and glue them together.
Clint
Thank you! That is just TOO easy.
Here is a Tips & Tricks on the process: http://www.carvewright.com/assets/ti...icks_Jul09.pdf
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!