Results 1 to 4 of 4

Thread: Carving pattern larger than machine limit...

  1. #1

    Question Carving pattern larger than machine limit...

    How do I carve a pattern that will be 45" by 42" ? I seem to remember someone explaining it at the conference a year or two ago, but the instructions didn't seem to find a home in my memory. Thanks!

  2. #2
    Join Date
    Sep 2008
    Location
    Nuevo, CA
    Posts
    1,854

    Default

    You carve it on 3 boards. You would put the bottom 1/3 on an 11" board 1/4" from the bottom edge, save that as bottom, slide the whole thing down until it is centered vertically, save that as middle. Then slide everything down until the top is 1/4" fro the top edge and save that as top. Now carve those 3 boards on 12" wide boards so you have edges for the rollers to ride on. YOU will have to trim the pieces to line-up, and glue them together.
    Clint
    CarveWright StartU team member
    Web Site WWW.clintscustomcarving.com

  3. #3

    Default

    Thank you! That is just TOO easy.

  4. #4
    Join Date
    Aug 2008
    Location
    The Great Texas Gulf Coast
    Posts
    5,314

    Default

    Here is a Tips & Tricks on the process: http://www.carvewright.com/assets/ti...icks_Jul09.pdf
    CarveWright CX Packaged System - starting at $2000
    CarversClub 1 Year Subscription - $150.00/year
    Adv. Support w/out CC membership - $25.00/issue
    CarveWright Community Forum - PRICELESS!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •